The following video introduces the approach of the STFES group to a Master thesis:

• Aerodynamic design and optimization of the front wing of the UGent Racing car using suspension controlled active aerodynamics
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Allam Fetvedt cycle impact and design of the main heat exchangers
  Supervisors: prof. dr. ir. Michel De Paepe en prof. dr. ir. Steven Lecompte
  Degree: Master of Science in Electromechanical Engineering
• Balancing the sound generation and efficiency of a centrifugal fan by optimizing the tongue geometry
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Developing an actuator line method for tether modeling in airborne wind energy systems
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Development and Testing of Electric Motor Oil Jet Cooling on a Thermal Measurement Setup
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Development of an actuator annular method for the simulation of airborne wind energy systems
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Development of Equations of State for low GWP refrigerants based on flow calorimetry measurements
  Supervisors: prof. dr. ir. Steven Lecompte en prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Development of second-generation biofuels, aiming at road vehicle climate impact reduction for spark ignited engines
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Development of state-of-the-art thermocouple calibration setup
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in de industriële wetenschappen: elektromechanica - Campus Schoonmeersen
• Dual-fuel engine modelling with hydrogen and methanol
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Dynamic modelling of a Rankine-based Carnot battery
  Supervisors: prof. dr. ir. Steven Lecompte en prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Experimental characterization of a solar boiler as a sensible thermal energy storage
  Supervisors: prof. dr. ir. Michel De Paepe en dr. ir. Wim Beyne
  Degree: Master of Science in de industriële wetenschappen: elektromechanica - Campus Schoonmeersen
• Experimental determination of the heat transfer to low GWP refrigerants in the supercritical region
  Supervisors: prof. dr. ir. Michel De Paepe en prof. dr. ir. Steven Lecompte
  Degree: Master of Science in de industriële wetenschappen: elektromechanica - Campus Schoonmeersen
• Experimental investigation of flow boiling heat transfer under non-uniform and non-constant heat flux conditions
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Experimental testing and modelling of a compressor with two-phase injection capabilities.
  Supervisors: prof. dr. ir. Steven Lecompte en prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Experimentally validating a model for evaporation rate of a metastable fluid within a reciprocating piston.
  Supervisor: prof. dr. ir. Steven Lecompte
  Degree: Master of Science in Electromechanical Engineering
• Exploring the knock-resistive properties of methanol on a diesel engine retrofitted to spark ignition
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Flow and heat transfer simulations of the main motor of a weaving machine
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Fluid-structure interaction and heat transfer of a wire-wrapped fuel assembly
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Fluid-structure interaction simulations of floating photovoltaics
  Supervisor: prof. dr. ir. Joris Degroote en prof. dr. ir. Peter Troch
  Degree: Master of Science in Electromechanical Engineering
• Fluid-structure interaction simulations of turbulence-induced vibrations using the Pressure Fluctuation Model
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Fuel spray characterization of a novel second-generation biofuel and drop-in biofuel blends
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Identifying and experimentally testing oil/refrigerant mixtures for high temperature heat pumps
  Supervisor: prof. dr. ir. Steven Lecompte
  Degree: Master of Science in Electromechanical Engineering
• Improving the efficiency of oil-injected screw compressors
  Supervisors: prof. dr. ir. Joris Degroote en prof. dr. ir. Dieter Fauconnier
  Degree: Master of Science in Electromechanical Engineering
• Improving window frame insulation by avoiding water entrainment
  Supervisors: prof. dr. ir. Joris Degroote en prof. dr. ir.-arch. Nathan Van Den Bossche
  Degree: Master of Science in Electromechanical Engineering
• Introducing second-generation biofuels in CI engines for future road vehicle climate impact reduction
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Investigating the thermal performance of pig stables
  Supervisor: prof. dr. ir. Steven Lecompte
  Degree: Master of Science in Electromechanical Engineering
• Measurements on power electronics cooling with immersion boiling
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Mobile latent thermal energy storage as heat source for a heat island
  Supervisors: prof. dr. ir. Michel De Paepe en dr. ir. Wim Beyne
  Degree: Master of Science in Electromechanical Engineering
• Modelling of different cooling technologies for SiC and GaN power electronics
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Modelling Plant Behaviour at the Microscopic and Macroscopic Level Using CFD
  Supervisors: prof. dr. ir. Michel De Paepe en prof. dr. Kathy Steppe
  Degree: Master of Science in Electromechanical Engineering
• Modelling the structural behavior of a natural staple fiber yarn at the level of fibers
  Supervisors: prof. dr. ir. Lode Daelemans en prof. dr. ir. Joris Degroote
  Degree: Master of Science in Sustainable Materials Engineering
• Numerical investigation of flow-induced vibrations of a tube bundle subject to two-phase cross-flow
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Numerical study on the hydraulic performance of hydrostatic bearings in lead-bismuth eutectic
  Supervisors: prof. dr. ir. Dieter Fauconnier en prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Optimization of Heat Pump Refrigrant Charge For Optimal Off-Design Performance
  Supervisors: prof. dr. ir. Michel De Paepe en prof. dr. ir. Steven Lecompte
  Degree: Master of Science in Electromechanical Engineering
• Optimization of the outlet geometry of tooth compressors
  Supervisors: prof. dr. ir. Steven Lecompte en prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Optimization under uncertainty of a supersonic air jet nozzle
  Supervisors: prof. dr. ir. Joris Degroote en dr. ir. Jolan Wauters
  Degree: Master of Science in Electromechanical Engineering
• Optimizing a medium-speed large-bore SI engine operated with methanol
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Performance and emissions modelling of a marine ABC Engine
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Research into alternative fuels for (ultra) light aircraft internal combustion engines
  Supervisor: prof. dr. ir. Sebastian Verhelst
  Degree: Master of Science in Electromechanical Engineering
• Simulating and analyzing an airborne wind energy system on top of a conventional wind turbine
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Study of the flow field and uniformity of the temperature in a ventilated room
  Supervisors: prof. dr. ir. Joris Degroote en prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• System architecture design for a sustainable district heating system in the city of Ghent
  Supervisors: prof. dr. ir. Michel De Paepe en dr. ir. Wim Beyne
  Degree: Master of Science in Electromechanical Engineering
• The effect of air entering a wet clutch on cooling performance
  Supervisors: prof. dr. ir. Joris Degroote en prof. dr. ir. Dieter Fauconnier
  Degree: Master of Science in Electromechanical Engineering
• Thermal modeling of the liquid steel temperature in the tundish during casting at the continuous caster
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Thermal modeling of the wound rotor of EESM for multi-disciplinary multi-objective design optimization
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Thermal modelling and optimization of a high performance powertrain
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Thermodynamic Modelling of High-Temperature Heat Pumps
  Supervisors: prof. dr. ir. Steven Lecompte en prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Three-dimensional Fluid-Structure Interaction modelling of dry wire drawing process
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Trajectory generation and simulation for a large-scale reference Airborne Wind Energy system
  Supervisor: prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Understanding and improving the lubrication of oscillatory loaded bearings in rapier weaving looms
  Supervisors: prof. dr. ir. Joris Degroote en prof. dr. ir. Dieter Fauconnier
  Degree: Master of Science in Electromechanical Engineering
• Vibration and wear testing of a novel electric motor cooling method
  Supervisor: prof. dr. ir. Michel De Paepe
  Degree: Master of Science in Electromechanical Engineering
• Wall slip effects in lubricated contacts in TEHL regime
  Supervisors: prof. dr. ir. Dieter Fauconnier en prof. dr. ir. Joris Degroote
  Degree: Master of Science in Electromechanical Engineering
• Watertightness of window frames: experimental study of water droplet transport
  Supervisors: prof. dr. ir.-arch. Nathan Van Den Bossche en prof. dr. ir. Joris Degroote
  Degree: Master of Science in de industriële wetenschappen: bouwkunde, Master of Science in de ingenieurswetenschappen: architectuur